LMCK Premade bag packing machine

Standard operating procedure SOP for round bottle labeling machine

First, boot preparation

1) Confirm whether the label volume meets the specifications, install and check it as required; (If there is any change in product specifications, please refer to Annex 5)
2) When configuring the printer, confirm whether all parts of the printer are adjusted well and whether the grain meets the specifications, otherwise it should be adjusted as required;
3) Check whether the position of the label header is correct, otherwise it should be adjusted to ensure
a. The outgoing header should be close to the bottle belt and flush with the bottle belt;
b. Use the header to peel the edge of the plate parallel to the bottle bus

d. Adjust the electric eye sensitivity of the label, so that it can detect the sensing points on the label, so as to realize the marking.
4) Check whether the height and width of the conveyor belt guardrail have been adjusted to match the bottle body, and the material should be smoothly passed, otherwise it should be adjusted;
5) Check whether the height and position of the parting wheel have been adjusted to match the bottle body, and the bottle should be uniformly passed, otherwise it should be adjusted;

6) Check whether the position of the push plate is adjusted to match the bottle body, and the distance between the push plate and the bottle belt is slightly less than the diameter of the bottle, so that the label can be smoothly rolled and attached to the bottle body

Second, boot operation

1. Turn on the power switch (located on the right of the cabinet).
2. Rotate the compressed air switch to the open position and adjust the air pressure to 0.5~0.6Mpa(with printer)
3. Tap on the touch screen controller to enter the normal operation page.
4. Operation
5. Manual operation, check whether all parts have been adjusted properly, whether the operation is smooth, otherwise it should be stopped for adjustment.
6. Call and confirm the corresponding product program or enter the “Parameter setting” interface for parameter setting.

Operation

3. Manual operation, check whether all parts have been adjusted properly, whether the operation is smooth, otherwise it should be stopped for adjustment.
4. Call and confirm the corresponding product program or enter the “Parameter setting” interface for parameter setting. (See Annex 6 for parameter Settings)
5. Set the value of each counter as needed.
6. Press the Start button to run the machine online and enter the normal production state.
7. Press the SCram switch when the device is faulty or in an emergency.

Fourth, Shutdown Procedure

1, press the “Stop” button, the whole system stops, and then turn off the main power switch.
2, in case of emergency, directly press the emergency stop switch, restart the emergency stop switch or power switch, should ensure that the system is in a safe state.

When the machine is not used for a long time, the power cord should be unplugged, the surface of the machine should be clean, and the dust storage should be covered.
Note:
① When the remaining number of labels is equal to or less than the set value, the system will stop and alarm.
② For the printer, see the printer Operation and maintenance manual for the printer adjustment