LKBK Tea bag packing machine

(1) Check whether the specifications of the container cup and bag maker are in line with the requirements before opening the particle automatic packaging machine.
(2) Use the hand to dial the main motor belt to see whether the machine is flexible, and when it is confirmed that the machine has no abnormal conditions, it can be powered on.
(3) Under the machine, the packaging material is installed between the two paper wheels, and the machine is placed in the slot of the paper arm plate. The paper wheel should clamp the core of the material installed, so that the packaging material is aligned with the bag maker, and then the knob on the stop sleeve is tightened, and the printing surface is to the front or the composite surface (i.e. the polyethylene surface) is to the back. After starting up, adjust the axial position of the packaging material on the paper holder wheel according to the paper feeding condition to ensure the normal paper supply.
(4) Turn on the main power switch of the particle automatic packaging machine, press down the clutch handle, so that the measuring mechanism is separated from the main drive, turn on the start switch, and the machine runs empty.
(5) If the conveyor belt rotates clockwise, it should be stopped immediately, and the main motor is reversed at this time, and the belt is turned counterclockwise after the motor is reversed.
(6) Set the temperature, according to the packaging material used, set the heat sealing temperature on the temperature controller of the electric control box.
(7) Bag length adjustment Insert the packaging material into the bag maker according to the relevant regulations, clamp between the two rollers, turn the roller, pull the packaging material below the cutting knife, after reaching the set temperature for 2 minutes, switch on the start switch, loosen the lock nut of the bag length adjustment screw, adjust the bag length controller knob, turn clockwise to shorten the bag length, vice versa, after reaching the required bag length, Tighten the nut.
(8) Determine the position of the cutter, when the bag length is determined, remove the cutter, switch on the starting switch to continuously seal several bags, when the heat sealer has just opened, before the roller has not pulled the bag, immediately stop. Then move the left cutter first, align the knife edge with the middle of the transverse sealing path of integer times the bag length (generally 2 to 3 times the bag length), and make the blade perpendicular to the straight paper direction, tighten the fastening screw of the left cutter, lean the right cutter on the left cutter, and let the knife tip to the knife tip after laying flat, slightly tighten the fastening screw in front of the stone cutter, and press the back of the right cutter down. So that there is a certain pressure between the two knives, tighten the fastening screw behind the right knife, put the packaging material between the blade, slightly down the front of the right knife, to see whether the packaging material can be cut off, otherwise it should continue to be not cut until it can be cut off, and finally tighten the front screw.
(9) When stopping, the heat sealer must be in an open position to prevent burning the packaging material and extend the service life of the heat sealer.
(10) When rotating the measuring disc, it is not allowed to turn the measuring disc in the clockwise direction. Before starting the machine, check whether the feeding doors are closed (except the feeding doors in the open state), otherwise the parts may be damaged.
(11) Metering adjustment When the metering weight of the packaging material is less than the required weight, the adjustment screw of the metering disk can be adjusted clockwise to achieve the required packaging amount, and the reverse if it is greater than the required weight.
(12) After the charging operation is not abnormal, the machine can work normally, turn on the counter switch, you can complete the counting work, and finally install the protective cover.